Test everything to ensure it is working as it should be. If everything is done as per the requirement, your LED will flash at the required rate. Additionally, an oscilloscope may be handy at this point if you wish to repair the circuit. It is not appealing, but it works perfectly. Solder the new circuit using a point-to-point connection to the original connector. If Google is your friend, you will find much information on the 555 timer, such as using programs to calculate the C and R values. For C and R values, the flash rate is about 85 flashes per minute or 85 Hz.

Besides, you can regulate the flash rate and duty cycle to C1, R1, and R2. It comes with a robust power transistor rated at 10A. The new LED flasher circuit features a power transistor and a 555 timer circuit. You can re-use the initial connector and fix your new circuit onto it using a solder. If not, since they have a pot on the timing circuit, use a hacksaw to cut the flasher case open. Most of the flasher units are disassemble. Step 2: Get the Old Circuit out of the LED Flasher unit Alternatively, you can switch on the turn signal lights and listen to the clicking noise. Otherwise, get in touch with your service manual to help you locate the flasher unit. The location is not the same on all vehicles. Step 1: Identify and detach the LED Flasher Unitįirstly, locate and detach the flasher unit. As long as your turn signal lights are on, your emergency flasher is active. They warn other motorists of an emergency condition you are in or to show that you’ve packed your car on the roadside. These lights become active immediately the driver pushes the hazard light switch. Emergency Light Flasher ModuleĮmergency light flashers are also known as hazard lights. Do not forget that the metric model repeatedly alternates, which may not be a solution to rapid flash. No Load LED Flasher allows you to install LED turn signals with a moderate flash. The LED flasher relay flashes faster or even stops when the bulb blows out since little or no current is flowing. After switching off the current, the metallic strip cools and closes again. A double metallic strip heats up as the current flows through it then opens up. The LED flasher relay motorcycle works uniquely.

Rodstar turn signal flasher led